Extra Retraction at Start - UltiMaker Cura - UltiMaker Community
Por um escritor misterioso
Descrição
Can someone explain why I am getting an extra retraction command right before my skirt starts? When I print, the filament doesn't print for sometime because of the extra retraction. I have tried it in both 3.4.1 and 3.5. Maybe I have a setting that is checked or set wrong. Below is my gcode from
Enable retraction options when lift head option is enable · Issue
Cura not retracting correctly - UltiMaker Cura - UltiMaker
analyze retractions and Z hop - UltiMaker Cura - UltiMaker
10 Good Reasons to Use Cura
Bency test print on Ender 3X (Direct Drive) using PLA & Ultimaker
slicing - Ultimaker Cura not always telling extruder to retract
Layer Start and End Problems - LulzBot TAZ - LulzBot
ultimaker cura - Stuttering extrusion after layer change - 3D
too much retraction at beginning - Improve your 3D prints
Extra Retraction at Start - UltiMaker Cura - UltiMaker Community
Under Extrusion Near Z-Seam in Cura 5.0 Beta (Coasting Is Off Btw
de
por adulto (o preço varia de acordo com o tamanho do grupo)
