Hotend pauses on print for a few seconds after finish printing
Por um escritor misterioso
Descrição
Any one know how to change settings/gcod so that the hotend does not pause on the top layer after it finish printing? This leaves a dimple where it paused. Thanks!
Making Your 3D Printer Pause or Wait with G-Code in Marlin - 3D Print Gorilla
Quality Prints at High Speed: With PowerBoost 2.0 technology and Ultra Direct Extruder, AnkerMake M5C can achieve printing speeds of up to 500 mm/s
AnkerMake M5C 3D Printer, 500 mm/s High-Speed Printing, All-Metal Hotend, Supports 300℃ Printing, Control via Multi-Device, Intuitive, 7×7
How to Avoid 3D Print Stringing: The Ultimate Guide
Trying to find a command that changes the current state of the printer from printing to pause and vice versa - Improve your 3D prints - UltiMaker Community of 3D Printing Experts
3D-Print Guide 3D Prima - 3D-Printers and filaments
Retraction: Just say No to oozing
marlin - Hot end temperature varies during print - 3D Printing Stack Exchange
Z Seam (Cura): How to Hide It
3D-Print Guide 3D Prima - 3D-Printers and filaments
Extruder jams/clogs up after printing a little bit of filament – Hardware, firmware and software help – Prusa3D Forum
How To – Pausing a print at a specific layer. – The Neverending Projects List
de
por adulto (o preço varia de acordo com o tamanho do grupo)
/cdn.vox-cdn.com/uploads/chorus_asset/file/16319743/pogo_shiny_onix_steelix_anorith_armaldo_lileep_cradily.png)
